PP016M

Changing the Machine Operation Mode

If necessary, switch between various modes of machine operation.

The procedure for configuring Custom Settings is as follows:

  1. Make sure that the machine is on, and then select Custom Settings from the pop-up menu on the Canon IJ Printer Utility

    Note
    • If the computer is unable to communicate with the machine, a message appears because the computer cannot access the function information that was set on the machine.
      If this happens, click Cancel to display the most recent settings specified on your computer.

  2. If necessary, complete the following settings:

    Ink Drying Wait Time

    You can set the length of the machine rest time until printing of the next page begins. Moving the slider to the right increases the pause time, and moving the slider to the left decreases the time.
    If the paper gets stained because the next page is ejected before the ink on the printed page dries, increase the ink drying wait time.
    Reducing the ink drying wait time speeds up printing.

    Display Guide Message

    Displays a guide when you perform operations in which the paper setting procedure is complicated.

    Hagaki Printing

    Displays the guide message before the machine begins hagaki printing.
    To hide the guide messages starting from the next execution of other than plain paper printing, select the Do not show again check box in the displayed dialog.
    To display the guide messages again, display the Canon IJ Printer Utility pop-up menu, select Custom Settings, and then check the Hagaki Printing check box.

    Important
    • With Mac OS X v10.7, you cannot use Display Guide Message.
      Therefore, if you check the Do not show again check box when a guide message is displayed before printing starts, this will stop any more guide messages from being displayed.

    Prevent paper abrasion

    The machine can increase the gap between the print head and the paper during high-density printing to prevent paper abrasion.
    Check this check box to prevent paper abrasion.

    Align heads manually

    Usually, the Print Head Alignment function of Test Print on the pop-up menu in the Canon IJ Printer Utility is set to automatic head alignment, but you can change it to manual head alignment.
    If the printing results of automatic print head alignment are not satisfactory, see "Aligning the Print Head Position Manually from Your Computer," and perform manual head alignment.
    Check this check box to perform the manual head alignment. Uncheck this check box to perform the automatic head alignment.

  3. Apply the settings

    Click Apply and when the confirmation message appears, click OK.

    The machine operates with the modified settings hereafter.

Page top